CE Bagger Compliance Kit

1. Park the machine on a level surface, shut off the engine, engage the parking brake, and remove the key.

2. Remove the existing curtain by loosening the bolts holding the curtain to the frame and the mower deck (Figure 1).

   

   Figure 1

   1. Bolts
   2. Curtain

3. Remove the knob shown in Figure 2.

   

   Figure 2

   1. Knob
   2. Powered bagger cover
   3. Belt cover

Close section

Parts needed for this procedure:

Curtain	1
Bolt (1/4 x 5/8 inch)	1

1. Remove the bolts and retaining nuts from the straight rod in the existing curtain and retain the nuts and bolts.

2. Remove the straight rod from the existing curtain.

3. Install the straight rod into the new curtain and install the previously removed bolts and retaining nuts.

4. Install the new curtain to the frame and the mower deck using the existing hardware (Figure 3).

5. Install the bolt (1/4 x 5/8 inch) into the hole where the knob was removed (Figure 3).

   

   Figure 3

   1. Existing curtain hardware
   2. Bolt (1/4 x 5/8 inch)
   3. New curtain

Close section