Wear Block Kit

1. Park the machine on a level surface.

2. Remove any attachments from the machine.

3. Engage the parking brake.

4. Lower the loader arms so that they are approximately 20 to 25 cm (8 to 10 inches) above the frame.

5. Shut off the engine and remove the key.

6. Raise the machine off the ground until you can access the inside of the track beneath the machine. Support the machine using jack stands.

   Note: Use jack stands rated for your machine. Refer to the Operator’s Manual for your machine to determine the weight.

Close section

Complete the procedure for both tracks.

1. Remove the 2 existing bolts and outside, front wear block (Figure 1).

   

   Figure 1

   1. Bolt
   2. Existing wear block
   3. Front wheel

2. Apply thread-locking compound to the button-head bolts and use them to install the kit wear block (Figure 2).

   

   Figure 2

   1. Button-head bolt
   2. Kit wear block

3. Repeat the procedure for the inside of the track.

Close section