Rubber Flap Kit

1. Park the machine on a level surface.

2. Disengage the PTO, engage the parking brake, and move the motion-control levers outward to the NEUTRAL-LOCK position.

3. Shut off the engine and remove the key.

4. Lower the kickstands for the broom.

Parts needed for this procedure:

Install the upper flap and backing plate to the hood of the broom using 8 bolts and 8 nuts (Figure 1). Torque the bolts to 10 to 14 N∙m (90 to 100 in-lb).

Note: Ensure that the backing plate bends upward, toward the upper flap.

Figure 1

Bristles not shown

1. Hood
2. Bolt (8)
3. Upper flap
4. Nut (8)
5. Backing plate