Extended Control Levers Kit

1. Park the machine on a level surface.

2. Move the motion-control levers to the NEUTRAL-LOCK position.

3. Engage the parking brake.

4. Shut off the engine and remove the key.

Parts needed for this procedure:

Right control lever assembly	1
Left control lever assembly	1

1. Remove the existing 2 bolts from each control lever (Figure 2).

   Note: Retain the fasteners.

   

   Figure 2

   1. Existing control lever
   2. Existing bolt

2. Remove the existing control levers (Figure 2).

3. Loosely install each extended control lever using the previously removed 2 bolts.

   • To increase the lever height by 2.5 cm (1 inch), install the 2 bolts into the lower set of holes (Figure 3).

     

     Figure 3

     1. Extended control lever
     2. Lower set of holes
     3. Bolt

   • To increase the lever height by 5.7 cm (2-1/4 inches), install the 2 bolts into the upper set of holes (Figure 4).

     

     Figure 4

     1. Extended control lever
     2. Upper set of holes
     3. Bolt

1. Move the control lever forward or rearward to the desired position in the slotted hole (Figure 5).

   

   Figure 5

   1. Slotted hole

2. Torque the bolts to 41 N∙m (30 ft-lb).