Safety
Safety and Instructional Decals
 |
Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing. |
Setup
Preparing the Machine
-
Park the machine on a level surface.
-
Move the motion-control levers to the NEUTRAL-LOCK position.
-
Engage the parking brake.
-
Shut off the engine and remove the key.
Installing the Kit
Parts needed for this procedure:
| Bucket-holder mount | 1 |
| Bracket-support hinge | 1 |
| Mount strap—for 48, 52, and 60-inch decks | 1 |
| Mount strap—for 72-inch decks | 1 |
| Top bracket | 1 |
| Knob | 1 |
| Carriage bolt (5/16 x 7/8 inch) | 4 |
| Flange nut (5/16 inch) | 3 |
| Flange-head bolt (3/8 x 1 inch) | 1 |
| Locknut (3/8 inch) | 1 |
-
Install the bucket-holder mount into the deck-mounting hole by the discharge plate (Figure 2).
-
Secure the bracket-support hinge and mount strap to the bucket-holder mount using 3 carriage bolts (5/16 x 7/8 inch) and 3 flange nuts (5/16 inch) as shown in Figure 3.
Refer to Figure 4 for the proper mount strap. Use the mount strap with the 51 mm (2 inches) bend offset and 4 holes for 48, 52, and 60-inch decks. Use the mount strap with the 13 mm (1/2 inch) bend offset and 3 holes for 72-inch decks.
-
Secure the mount strap to the mower deck using the flange-head bolt (3/8 x 1 inch) and locknut (3/8 inch) as shown in Figure 5.
-
Secure the top bracket to the bucket-holder mount using the knob and a carriage bolt (5/16 x 7/8 inch) as shown in Figure 6.
Operation
Mounting a Bucket
Use only Toro-approved attachments and accessories. The maximum capacity is 7 kg (15 lb).
-
Loosen the knob and raise the top bracket. Tighten the knob to hold it in place (Figure 7).
-
Place the bottom lip of the bucket over the bottom ledge of the welded support bracket (Figure 7).
-
Loosen the knob and lower the top bracket as far as possible over the rim of the bucket. Tighten the knob (Figure 7).
