Bagging Enhancement Kit

1. Park the machine on a level surface, shut off the engine, engage the parking brake, and remove the key.

2. Remove the existing nuts and bolts from the ends of the existing baffles as shown in Figure 1.

   Note: Retain the hardware for use if you remove this kit.

   

   Figure 1

   1. Existing nut
   2. Existing baffle
   3. Existing bolt
   4. Side discharge chute

Parts needed for this procedure:

Front baffle	1
Right baffle	1
Left baffle	1
Carriage bolt (1/4 x 3/4 inches)	18
Locknut (1/4 inch)	18

Using the existing holes, install the front, right, and left baffles to the mower deck with 18 carriage bolts (1/4 x 3/4 inches) and 18 locknuts (1/4 inch) (Figure 2).

Note: The baffles will overlap each other.