2in or 6in L-Track Kit

1. Park the machine on a level surface.

2. Engage the parking brake.

3. Shut off the engine and remove the key.

Figure 1

Parts needed for this procedure:

1. Attach the bracket in the locations shown in Figure 2 using 2 screws (Figure 3).

   

   Figure 2

   1. Possible bracket locations
   2. Front of the bed
   

   Figure 3

   1. Coarse-threaded screws—2.03 to 2.50 N∙m (18 to 22 in-lb)
   2. Bracket
   3. Top of the bed
   4. Side of the bed
   5. Fine-threaded screws—4.52 to 5.10 N∙m (40 to 45 in-lb)

2. Install and use the ring assembly as shown in Figure 4.

   

   Figure 4

   15.2 cm (6 inches) L-Track bracket shown

   1. Correct position
   2. Incorrect position

Parts needed for this procedure:

1. Attach the bracket in the locations shown in Figure 5 using 2 screws (Figure 6).

   

   Figure 5

   1. Possible bracket locations
   

   Figure 6

   1. Coarse-threaded screws—2.03 to 2.50 N∙m (18 to 22 in-lb)
   2. Bracket
   3. Bed

2. Install and use the ring assembly as shown in Figure 4.

Parts needed for this procedure:

1. Attach the bracket in the locations shown in Figure 7 using 2 screws (Figure 8).

   

   Figure 7

   1. Possible bracket locations
   

   Figure 8

   1. Fine-threaded screws—5.2 to 6.8 N∙m (46 to 60 in-lb)
   2. Bracket
   3. Locknut (1/4 inch)

2. Install and use the ring assembly using 2 fine-threaded screws and locknuts (1/4 inch) as shown in Figure 4.