Door Mount Mirror Kit

Workman® GTX, HDX, and MD Utility Vehicles or Outcross Traction Unit with Cab

Model No. 136-1997-Serial No. and Up

Installation

Preparing the Machine

Preparing the Machine

Workman GTX, HDX, and MD

  1. Park the machine on a level surface.

  2. Engage the parking brake.

  3. Shut off the engine and remove the key from the key switch.

Preparing the Machine

Outcross 9060

  1. Park the machine on a level surface.

  2. Shift to the NEUTRAL position.

  3. Lower any equipped attachments.

  4. Engage the parking brake.

  5. Shut off the engine and remove the key.

Installing the Mirror Mounts

Parts needed for this procedure:

Left mirror mount1
Right mirror mount1
Left handle gasket1
Right handle gasket1
Side mirror arm assembly2
Rearview mirror arm assembly2
Flange-head screw (6 x 16 mm)4

  1. Remove the bolts, support plate, and nuts that secure the latch assembly to the handle mount (Figure 1).

    g272301

    Figure 1

    1. Bolt
    2. Support plate
    3. Nut
    4. Latch assembly

  2. Remove the latch assembly from the handle mount.

  3. Remove the mounting nut, washer, flange-head screw (6 x 25 mm), 2 spacers, and 2 grommets from the door handle, and remove the door handle (Figure 2).

    Note: Retain the door handle, mounting nut, washer, 2 spacers, and flange-head screw (6 x 25 mm).

    Note: Discard the large and small grommets.

    g189865

    Figure 2

    1. Door handle
    2. Large grommet
    3. Large spacer
    4. Washer
    5. Mounting nut
    6. Flange-head screw (6 x 25 mm)
    7. Small spacer
    8. Small grommet

  4. Adhere the handle gasket to the mirror mount (Figure 3).

    g189934

    Figure 3

    1. Mirror mount
    2. Handle gasket

  5. Install the door handle using the adhered mirror mount and the previously removed mounting nut, washer, flange-head bolt (6 x 25 mm), and 2 spacers (Figure 4).

    g189935

    Figure 4

    1. Door handle
    2. Large spacer
    3. Adhered mirror mount
    4. Washer
    5. Mounting nut
    6. Flange-head bolt (6 x 25 mm)
    7. Small spacer

  6. Install the latch assembly to the handle mount using the hardware that you removed in step 1; refer to Figure 1.

  7. Install the mirror arm to the top holes of the mirror mount using 2 flange-head screws (6 x 16 mm) as shown in Figure 5.

    g189936

    Figure 5

    1. Mirror arm
    2. Flange-head screws (6 x 16 mm)
    3. Mirror mount

  8. Slide the mirror onto the mirror arm, and adjust the mirror to your desired angle (Figure 6).

    g189937

    Figure 6

    1. Mirror arm
    2. Mirror

  9. Tighten the screws on the back of the mirror to secure the mirror to the mirror arm (Figure 7).

    g189938

    Figure 7

    1. Screws

  10. Repeat this procedure on the other side of the machine.