Snow Cab Kit

Parts needed for this procedure:

1. Remove the snow-cleanout tool from the machine.

2. Install the right and left mounting brackets onto the frame as shown in Figure 1.

   

   Figure 1

   1. Square plastic cap (2)
   2. Bolt, 1/4 x 4-1/2 inches (2)
   3. Right mounting bracket
   4. Round plastic cap (4)
   5. Locknut (4)
   6. Small washer (12)
   7. U-bracket (4)
   8. Left mounting bracket
   9. Bolt, 1/4 x 4 inches (2)

3. Install the front posts and horizontal frame onto the left and right mounting brackets as shown in Figure 2.

   

   Figure 2

   1. Horizontal frame
   2. Locknut (2)
   3. Bolt, 1/4 x 3/4 inch (2)
   4. Front post (2)

4. Install the rear frame onto the mounting brackets as shown in Figure 3.

   

   Figure 3

   1. Bolt, 1/4 x 1 inch (2)
   2. Large washer (4)
   3. Rear frame
   4. Locknut (2)
   5. Round plastic cap (2)

5. Install the top frame onto the front posts and rear frame as shown in Figure 4.

   

   Figure 4

   1. Bolt, 1/4 x 5/8 inch (4)
   2. Locknut (4)
   3. Top frame

6. Ensure that the angle between horizontal frame and the rear frame is about 100° (Figure 5).

   

   Figure 5

7. Tighten all bolts.

8. Install the snow-cleanout tool onto the machine.

Parts needed for this procedure:

Unfold and install the cover over the frame. Secure it to the frame using the Velcro® brand hook-and-loop fastener tabs.

Figure 6