Installation

Preparing the Machine

Refer to your cutting unit Operator’s Manual for instructions to prepare the machine and cutting unit for installation.

Installing the Brush

Parts needed for this procedure:

Brush1
Screw2
Capscrew2
Clamp2
  1. Remove the plow bolt, washer and nut securing one of the height of cut (HOC) arms to the cutting unit side plate (Figure 1).

  2. Loosen the roller mounting screws in the HOC arms (Figure 1).

  3. Slide the HOC arm off the roller shaft (Figure 1).

  4. Slide the roller shaft out of the HOC arm on the opposite end of the cutting unit.

    g016701
  5. Loosely install a capscrew and nut onto each clamp (Figure 2). Do not tighten.

  6. Insert a shaft clamp onto each end of the roller shaft (Figure 2).

  7. Loosely install the roller to the cutting unit with the HOC arm and fasteners previously removed.

  8. Adjust to the desired height of cut and tighten HOC arm mounting fasteners.

  9. Position the brush between the front roller and the cutting unit as shown in Figure 2.

    g016702
  10. Center the brush on the roller.

  11. Move the scraper in or out until the desired roller clearance is attained. The scraper must not contact the roller. Ensure that the scraper is parallel to the roller.

  12. Tighten the capscrews and nuts securing the clamps to the roller shaft. Torque to 11 N∙m (96 in-lbs).

  13. Center the roller and brush between the HOC arms.

  14. Rotate the brush down until the desired turf contact is attained.

  15. Tighten the roller mounting screws.