Important: If you are installing the Under Toe Board Weight Kit onto a machine that already has an under toe board weight installed, use Part No. 321-10 (hex-head bolt 1/4 x 1-3/4 inches) to ensure that there is adequate bolt length.
Shut off the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.
Disengage the PTO, move the motion-control levers to the NEUTRAL-LOCK position, and engage the parking brake.
Parts needed for this procedure:
Toe-board weight | 1 |
Hex-head bolt (1/4 x 1-1/4 inches) | 4 |
Flat washer | 4 |
Locknut (1/4 inch) | 4 |
Secure the toe-board weight to the machine using the 4 hex-head bolts (1/4 x 1-1/4 inches), 4 flat washers, and 4 locknuts (1/4 inch) as shown in Figure 1.