Bucket Mount Kit

1. Park the machine on a level surface.

2. Disengage the blade-control switch.

3. Engage the parking brake.

4. Move the motion-control levers outward to the NEUTRAL-LOCK position.

5. Shut off the engine and remove the key.

Parts needed for this procedure:

1. Insert the rubber bumper into the bucket-support bracket (Figure 1).

   

   Figure 1

   1. Rubber bumper
   2. Bucket-support bracket

2. Secure the lower bucket bracket to the bucket-support bracket using the spring and locking pin (Figure 2).

   

   Figure 2

   1. Bucket-support bracket
   2. Locking pin
   3. Spring
   4. Lower bucket bracket

3. Secure the assembled lower bucket bracket and bucket-support bracket to the engine guard using 2 flange-head bolts (5/16 x 3/4 inch) and 2 flange nuts (5/16 inch) as shown in Figure 3.

   

   Figure 3

   1. Flange-head bolt (5/16 x 3/4 inch)
   2. Flange nut (5/16 inch)
   3. Assembled bracket
   4. Engine guard

4. Secure the upper bucket bracket to the engine guard using the carriage bolt (5/16 x 7/8 inch) and handle knob (Figure 4).

   

   Figure 4

   1. Handle knob
   2. Engine guard
   3. Upper bucket bracket
   4. Carriage bolt (5/16 x 7/8 inch)