UltraPlus Blower/Vacuum

• Read the instructions carefully. Be familiar with the controls and the proper use of the appliance.

• Never allow children to use the appliance.

• Never allow people unfamiliar with these instructions to use the appliance. Local regulations may restrict the age of the operator.

• Never operate the appliance while people, especially children, or pets are nearby.

• The operator or user is responsible for accidents or hazards occurring to other people or their property.

• While operating the appliance, always wear substantial footwear and long trousers.

• Do not wear loose clothing or jewelry that can be drawn into the air inlet (refer to the following figure). Keep long hair away from the air inlets.

  

  Figure 1

• Wear protective goggles and hearing protection while operating.

• To prevent dust irritation, wear a face mask.

• Before using, check the supply and extension cord for signs of damage and aging. Do not use the appliance if the cord is damaged or worn.

• Never operate the appliance with defective guards or shields, or without safety devices in place, such as the vacuum bag/vacuum tube or blower tube/inlet cover.

• Only use a CE approved, weather proof extension cord fitted with the proper plug for your location, according to local ordinances.

• Do not use the appliance on wet surfaces. Do not expose it to rain. Store it indoors.

• Do not handle plug or appliance with wet hands.

• Always direct the cord to the rear away from the appliance.

• If a cord becomes damaged during use, disconnect the supply cord from the mains immediately. Do not touch the cord before disconnecting the supply.

• Do not carry the appliance by the cord, use the cord as a handle, close a door on the cord, or pull the cord around sharp edges or corners. Keep the cord away from heated surfaces.

• Turn off all controls before unplugging.

• Do not unplug by pulling on cord. To unplug, grasp the plug, not the cord.

• Disconnect the appliance from the power source as follows:

  • Whenever you leave the machine

  • Before clearing a blockage

  • Before checking, cleaning, or working on the appliance

  • If the appliance starts to vibrate abnormally

• Operate the appliance only in daylight or in good artificial light.

• Do not overreach and keep your balance at all times.

• Always be sure of your footing on slopes.

• Walk, never run.

• Keep all cooling air inlets clear of debris. Do not put any object into openings. Do not use with any opening blocked.

• Never blow debris in the direction of bystanders.

• Use extra care when cleaning on stairs.

• Do not use to vacuum up flammable or combustible liquids, such as gasoline, or use in areas where they may be present.

• Do not vacuum anything that is burning or smoking, such as cigarettes, matches, or hot ashes.

• This appliance is provided with double insulation (i.e., Class 2 device). Use only identical replacement parts. See instructions for servicing of Double-Insulated (Class 2) appliances.

• Lightning can cause severe injury or death. If lightning is seen or thunder is heard in the area, do not operate the machine; seek shelter.

• Keep all nuts, bolts, and screws tight to be sure the appliance is in safe working condition.

• Check the vacuum bag frequently for wear or deterioration.

• Replace worn or damaged parts.

• If appliance is not working as it should, has been dropped, damaged, left outdoors, or dropped into water, return it to an Authorized Service Dealer.

• Use only genuine replacement parts and accessories.

• Store the appliance in a dry place.

This unit has a sound pressure level at the operator’s ear of 93 dBA, which includes an Uncertainty Value (K) of 1 dBA.

Sound pressure level was determined according to the procedures outlined in EN ISO 11201.

This unit has a guaranteed sound power level of 102 dBA, which includes an Uncertainty Value (K) of 1 dBA.

Sound power level was determined according to the procedures outlined in ISO 11094.

• Measured vibration level = 2.4 m/s²

• Uncertainty Value (K) = 1.0 m/s²

Measured values were determined according to the procedures outlined in EN ISO 20643.

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged or missing decals.

127–2293

1. Read the Operator's Manual.
2. Electric shock hazard—keep the blower out of the rain and other wet conditions.
3. Warning—disconnect the blower from the power outlet and read the instructions before servicing or performing maintenance.
4. Thrown object hazard—wear eye protection.
5. Thrown object hazard—keep bystanders away.
6. Contains recyclable materials, do not discard.

110-7434

1. Cutting/dismemberment hazard, impeller—stay away from moving parts.
2. Warning—disconnect the blower from the power outlet and read the instructions before servicing or performing maintenance.

Parts needed for this procedure:

Install the blower tube and the bottom inlet cover.

Important: The motor should not run unless the bottom inlet cover is locked in place.

Note: If the motor runs without the bottom inlet cover in place, do not use the appliance. Return it to an Authorized Service Dealer.

Figure 2

Parts needed for this procedure:

1. Remove the bottom inlet cover and the blower tube.

   

   Figure 3

2. Install the vacuum tube and secure it with the supplied fastener.

   Important: The motor should not run unless the vacuum tube is locked in place.

   Note: If the motor runs without the vacuum tube in place, do not use the appliance. Return it to an Authorized Service Dealer.

   Note: You may need to push the connector firmly to ensure that it seats all the way into the vacuum tube.

   

   Figure 4

3. Install the vacuum bag.

4. Adjust the bag strap as needed for comfortable operation.

Parts needed for this procedure:

1. Remove the vacuum bag and the vacuum tube.

   

   Figure 5

2. Install the blower tube and the bottom inlet cover.

   Important: The motor should not run without the bottom inlet cover locked in place.

   

   Figure 6

   Note: If the motor runs without the bottom inlet cover in place, do not use the appliance. Return it to an Authorized Service Dealer.

The power supply you use with this appliance should be a residential current device (RCD) with a tripping current of not more than 30 mA. Use only a CE approved extension cord recommended for outdoor use. Do not change the appliance or extension cord plug in any way.

Note: Do not use an extension cord over 45 m.

Important: Check the extension cord frequently during use for holes or cracks in the insulation. Do not use a damaged cord. Do not run the cord through standing water or wet grass.

Secure the extension cord to the appliance using the molded in cord-lock feature.

Figure 7

1. Cord lock
2. Extension cord

Install the power and concentrator nozzles into the blower tube to help reach into narrow spaces or to remove matted debris from hard surfaces.

Figure 9

1. Blower tube
2. Power nozzle
3. Concentrator nozzle
4. Cord wrap

Install the oscillator nozzle onto the blower tube to save time clearing hardscapes. It automatically sweeps the back-and-forth, creating a wider blowing path with less side-to-side wrist movement.

Figure 10

Note: Remove the oscillator nozzle before using the cord wrap to store the blower.

The appliance is intended for residential use only. Use it outdoors to move debris as needed.

The appliance used as a vacuum is intended for residential use only. Use it outdoors to collect debris as needed.

Figure 11

Important: Vacuum only dry leaves and soft items. Hard items such as sticks, rocks, acorns, and pine cones will damage the impeller.

Important: Do not force the vacuum tube into a pile of debris or hold the tube upright while force feeding debris into the tube. Either action may clog and damage the impeller. If the vacuum starts to vibrate or make abnormal noise, stop it, unplug the cord, and check for the cause.

1. Turn off the appliance and unplug it from the power source.

2. Empty any debris from the bag.

   

   Figure 12

   Do not store debris in the bag. To clean the bag, turn it inside out and shake out any excess debris. Once a year, hand wash the bag in soapy water and allow it to air dry.

   Danger

   Normal usage of the bag causes it to wear and deteriorate over time. A worn or deteriorated bag allows small objects to be thrown through the bag, possibly injuring you or bystanders.

   Check the bag frequently. If it is worn or deteriorated, replace it with a genuine Toro vacuum bag.

   Always use the shoulder strap whenever you use the appliance with the bag. This prevents the bag from dragging on the ground, reducing bag wear and deterioration.

1. Turn off and unplug the appliance from the power source and wait for all moving parts to stop.

2. Remove the vacuum tube then remove the debris from impeller blades.

   

   Figure 13

3. Check the impeller for any signs of damage. If it is damaged, contact your Authorized Toro Dealer.

4. Install the vacuum tube or, if you want to switch to blower mode, the bottom inlet cover. Refer to Converting from Blower to Vacuum or Converting from Vacuum to Blower for more information.