Dingo® Reflector Kit

Park the machine on a level surface in a warm area.

Lower the attachments.

Engage the parking brake.

Shut off the engine and remove the key.

Wait for all moving parts to stop.

If the machine is cold, allow the steel surfaces at the back of the machine (Figure 1 and Figure 2) to warm.

Figure 1

TX427 and TX525 Machines

Figure 2

TX1000 Machines

Use alcohol and a clean rag to wipe clean the mounting surface of the rear-support cover where you will apply the reflector decal (Figure 3).

Figure 3

1. Rear access cover
2. Rear-support cover
3. Reflector decal
4. 10 mm (3/8 inch)
5. 3 mm (1/8 inch)—outboard of rear access cover

Ensure that the decal mount surface of the support cover is dry.

Remove the backing from the reflector decal.

Adhere the decal to the rear-support cover as shown in Figure 3.

Repeat steps 1 through 4 at the other rear-support cover.

Use alcohol and a clean rag to wipe clean the mounting surface of the tank plate where you will apply the reflector decal (Figure 4).

Figure 4

1. 13 mm (1/2 inch)—inboard of bend radius
2. 13 mm (1/2 inch)
3. Reflector decal
4. Tank plate

Ensure that the decal mount surface of the tank plate is dry.

Remove the backing from the reflector decal.

Adhere the decal to the tank plate as shown in Figure 4.

Repeat steps 1 through 4 at the other tank plate.