Side View Mirror Kit

1. Park the machine on a level surface.

2. Shift the transmission lever to the P (Park) position.

3. Shut off the engine and remove the key.

Parts needed for this procedure:

1. Secure the mirror to the mirror bracket using 2 torx-head screws (Figure 1).

   

   Figure 1

2. Secure the mirror assembly to the ROPS bracket using 2 torx-head screws (Figure 2).

   

   Figure 2

3. Torque each screw to 26 N∙m (228 in-lb).

4. Repeat this procedure on the other side of the machine.

Parts needed for this procedure:

1. Remove the existing 2 torx-head screws, 2 washers, and 2 locknuts (6 mm) from the cab door (Figure 3).

   

   Figure 3

2. Secure the mirror to the door using 2 torx-head screws (M8 x 16 mm) as shown in Figure 4.

3. Torque each screw to 26 N∙m (228 in-lb).

   

   Figure 4

4. Repeat this procedure on the other side of the machine.