Jack Mount Kit

Zero-Turn-Radius Side-Discharge or Rear-Discharge Riding Mower

Model No. 144-1993-Serial No. and Up

Safety

Safety and Instructional Decals

Graphic

Safety decals and instructions are easily visible to the operator and are located near any area of potential danger. Replace any decal that is damaged or missing.
decal127-6663

127-6663

  1. Warning—read the Operator's Manual.
  2. Crushing hazard—engage the parking brake, shut off the engine, and remove the key; support the machine using jackstands.

Installation

Preparing the Machine

  1. Park the machine on a level surface.

  2. Disengage the blade-control switch.

  3. Move the motion-control levers outward to the NEUTRAL-LOCK position.

  4. Engage the parking brake.

  5. Shut off the engine and remove the key.

Installing the Jack Mount

Parts needed for this procedure:

Jack mount1
Bolt2
Locknut2
Backer plate1

Z Master

Note: You need only 1 bolt for this procedure; discard the other bolt.

  1. Remove the floor pan.

  2. Remove the bumper from the cross member as shown in Figure 1.

    g388353

    Figure 1

    1. Cross member
    2. Bumper

  3. Secure the jack mount to the frame using 1 bolt, 2 locknuts, backer plate, and the previously removed bumper (Figure 2).

    g388365

    Figure 2

    1. Bumper
    2. Jack mount
    3. Locknut (2)
    4. Bolt
    5. Backer plate

  4. Install the floor pan.

Titan

Secure the jack mount to the frame using the 2 bolts, 2 locknuts, and the backer plate (Figure 3).

g388367

Figure 3

  1. Bolt (2)
  2. Jack mount
  3. Locknut (2)
  4. Backer plate

Operation

Using the Jack Mount

Warning

The machine could fall onto someone and cause serious injury or death.

  • Do not keep the machine raised on the jack for extended periods of time.

  • Always use a jack on a level surface.

  • Ensure that the jack is secured properly to the jack mount using a jack pin.

  • Do not rely solely on the jack for support. Use adequate jack stands or equivalent support.

  • Do not mount or dismount the mower while the jack is raised.

  • Before each use, ensure that the jack and jack mount work properly and that there are no signs of damage.

Note: Use only a manufacturer-approved jack rated at 907 kg (2,000 lb) or higher lift capacity with the jack mount.

  1. Park the machine on a level surface, disengage the blade-control switch, move the motion-control levers outward to the NEUTRAL position, and engage the parking brake.

  2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving the operating position.

  3. Attach the jack to the jack mount with a jack pin (Figure 4).

    g388412

    Figure 4

    1. Jack mount
    2. Jack pin
    3. Jack tube
    4. Jack

  4. Use the jack to raise the machine to the desired height.

    Warning

    Raising the machine could cause a fuel leak. Fuel is extremely flammable and highly explosive.

    • Check for any fuel leaks before performing maintenance.

    • If you see a fuel leak, immediately lower the machine, drain the fuel, and wipe up the spill.

  5. Support the machine with jack stands; refer to the machine Operator’s Manual for jack stand placement.

  6. When finished, use the jack to lower the machine, then remove the jack.

    Note: Do not operate the machine with the jack attached.