Preparing the Machine
-
Park the machine on a level surface.
-
Disengage the PTO and move the motion-control levers
outward to the NEUTRAL position.
-
Shut off the engine and remove the key.
-
Raise the machine so that the tires are off the ground
or disengage the transmission sun gear; refer to your machine Operator’s Manual.
Installing the Harness Adapter Kit
Grandstand
® machine
-
Flip open the wire-harness access cover at the rear
of the machine and remove the connector plug (Figure 1).
-
Connector the harness adapter to the connector (Figure 2).
Installing the Harness Adapter Kit
Z Master
® machine
-
Remove the connector plug that is located underneath
the right rear fender of the machine (Figure 3).
-
Connect the harness adapter to the connector (Figure 4).