Installation

Preparing the Machine

  1. Park the traction unit on a level surface.

  2. Ensure that the transmission is in neutral.

  3. Lower all attachments (if equipped).

  4. Engage the parking brake.

  5. Shut off the engine and remove the key.

Installing the Kit

Parts needed for this procedure:

Hose2
Straight fitting4
Quick-connect coupler2
Female coupler2
Black dust cap1
Red dust cap1
Dust plug2
  1. Assemble the kit to the machine as shown in Figure 1.

    Important: Refer to the machine Operator’s Manual for directions to install hydraulic hoses in the proper hydraulic-flow direction.Ensure that the red dust cap is installed on the extend port and the black dust cap is installed on the retract port.

    g430075

Confirming the Correct Attachment Operation

  • Pro Sweep® machines: Ensure that the brush rotates in a clockwise direction when viewed from the motor end. If the brush is rotating counterclockwise, reverse the hydraulic hose connections.

  • ProPass machines: Ensure that the pressure hose is connected to the extend port and the return hose (which has an inline check valve) is connected to the retract port.

  • Other attachments: Refer to the Operator’s Manual to determine compatibility with the hydraulic system.