Weight Kit

Parts needed for this procedure:

1. Park the machine on a level surface.

2. Shut off the engine.

3. Remove the key.

4. Wait for all moving parts to stop.

5. Disconnect the spark-plug wire.

6. Use a proper lifting device to gain access to the bottom of the machine.

7. Remove the 2 screws (1/4 x 3/4 inch) and 2 washers (1/4 inch) securing the lower frame support to the bottom of the machine. Retain the washers.

   

   Figure 1

8. Install the weight plate to the lower frame support and secure it with the 2 hex-washer-head screws (1/4 x 1-1/4 inches) and 2 retained washers (1/4 inch).

   

   Figure 2

9. Return the machine to an upright position.

10. Connect the spark-plug wire.