Switch Panel

1. Carefully remove the backing from the decal (Figure 3).

   

   Figure 3

   1. Rectangular opening (decal)
   2. Hole (decal)
   3. Rectangular opening (switch panel)
   4. Hole (switch panel)

2. Align the rectangular openings and hole in the decal with the rectangular openings and hole in the switch panel as shown in Figure 3.

3. Apply the decal to the switch panel.

1. Align the plug to the rectangular openings in the switch panel (Figure 4).

   

   Figure 4

   1. Rectangular opening (switch panel)
   2. Plug

2. Insert the plug into the opening until the plug snaps securely into the panel (Figure 4).

3. Repeat step 1 and 2 for the 3 other plugs (Figure 4).

Align the wire harness to the switch panel as shown in Figure 5.

Figure 5

1. Align the square holes in the switch panel with the square holes in the 2 side-frame channels of the sunshade as shown in Figure 6.

   

   Figure 6

   1. Carriage bolt
   2. Square hole (side-frame channel)
   3. Square hole (switch panel)
   4. Nut

2. Assemble the switch panel to the side-frame channels (Figure 6) with the 4 carriage bolts and 4 nuts.

3. Torque the nuts to 419 to 513 N∙cm (37 to 47 in-lb).

1. Route the wire harness of the switch panel kit along the roll-bar tube as shown in Figure 7.

   

   Figure 7

   1. Roll-bar tube
   2. Kit wire harness
   3. Cable ties

2. Route the wire-harness end labeled P08 through the platform grommet (Figure 7).

   

   Figure 8

   1. Wire harness
   2. Platform grommet

3. Secure the wire harness to the roll-bar tube with the cable ties as needed (Figure 7).

4. Raise the hood and connect the kit wire-harness connector labeled to the machine wire-harness connector labeled .

   Note: The P19 connector is located above the hydraulic-tank cap.