EU Charger Connector Kit

Groundsmaster® e3200 or e3300 Traction Unit

Model No. 161-5101-Serial No. and Up

Installation

Preparing the Machine

  1. Park the machine on a level surface.

  2. Ensure that the parking brake is engaged.

  3. Shut off the machine and remove the key.

  4. Turn the battery-disconnect switch to the OFF position.

Removing the Existing Charger Connector

  1. Remove the bolts and screws that secure the cover to the left side of the machine (Figure 1) and remove the cover.

    g515696

    Figure 1

    1. Bolts
    2. Screws
    3. Cover

  2. Remove the hardware that secures the charger connector and connector plate to the frame panel (Figure 2).

    g515709

    Figure 2

    1. Connector plate
    2. Charger connector
    3. Bolt
    4. Screw

  3. Unplug the charger connector from the charger-wire-harness connector and remove the charger connector from the machine.

Installing the Charger Connector

Parts needed for this procedure:

Charger connector1
Connector plate1
Screw (5/16 inch)2

  1. Use 2 screws (5/16 inch) and the existing screws, washers, and nuts on the charger connector to secure the connector and connector plate to the frame panel (Figure 3).

    g515516

    Figure 3

    1. Nut
    2. Flat washer
    3. Lock washer
    4. Connector plate
    5. Charger connector
    6. Screw
    7. Screw (5/16 inch)

  2. Install the wire-harness connectors for the charger connector as follows:

    • Connector labeled P02: Connect to the machine-wire-harness connector labeled P31 (CHARGER PORT INTERCONNECT).

    • Connector labeled P03: Connect to the AC-inlet connector labeled P02 (AC CHARGE PORT).

  3. Use the previously removed screws and bolts to secure the cover to the left side of the machine (Figure 4).

    g515696

    Figure 4

    1. Bolts
    2. Screws
    3. Cover